ZFW between Topcat and fuel Planner is close however take off and landing weight is way out.ĭoes any one have suggestions on what I am doing wrong. I just have not been able to get all 3 to match so obviously doing something wrong.įor example, with Zero fuel Weight I have the following
I then have the same issue when trying to get the figures in the fuel Planner to agree with PFPX and Topcat. Assume I have Dry Operating weight wrong as well but not found it in PFPX yet. My problem is that I am not able to get the figures between all 3 to agree with each other.įor example, between PFPX and topcat the figures are different for Zero Fuel Weight, Takeoff Weight and Landing weight. So at this stage I have PFPX, Topcat and the fuel Planner open. Start up the flightsim, begin updating the MCDU and then open up the Fuel Planner to load fuel and payload into the airbus.
Then send the data to Topcat to get the Takeoff data. I create the flight in PFPX and release the flight. So while i have pretty much mastered the airbus and its fuel planner I am a newbie with Topcat and PFPX. I have flown around 150 flights since buying the Airbus Extended back in December then purchased Topcat a few weeks ago and finally PFPX.
